Categories
Contact Us

TEL:+86-755-23765496

E-mail:info@leomay.com

Add:No.3178,Renmin Road,Minzhi Street,Longhua District,Shenzhen City,Guangdong Province,China


Industry knowledge
Show you how LED power is produced
Mar 19, 2018

1, SMT patch IC, SMD resistor, SMD capacitor and some materials to be SMT processing, here we mainly use red gum technology, through the dispensing machine or printing presses, filling in the middle of two pads, and then through the patch, reflow soldering finish curing.

Finally, over the wave soldering surface mount that side of the wave soldering, and no need to complete the welding process.

2. Component Shaping In order to facilitate the subsequent plug-in work, the plug-in material needs to be shaped to achieve a certain degree of efficiency.

Anters components are the use of large brands of electronic materials, so that the production of power supply life and quality can be guaranteed.

3, Plug-ins 

We have several plug-in cable to ensure that the back of the wave soldering is effectively used.

4, Wave soldering

Working hours open all day work, insert a good piece, placed in the fixture, through the conveyor belt into the wave soldering machine, after the welding has been good.

5. Cutting feet

From the wave soldering out, the Power plate on the wire is very long, need to be cut feet.

6, after welding

After the welding line again for the appearance of inspection, repair welding, welding lines, such as a series of processes, the next step can be tested.

7, testing

Electrical performance Testing, parameter testing, the production of power to meet customer demand parameters, there is no bad, can be detected from here.

8, potting Anters part of the circular power needs to be filled with half plastic, waterproof power supply must be filled with glue. Of course, there is a part of the direct bare board power supply can skip this process.

The figure below is a pallet potting.

9, Aging If the power supply is not aging on the ship, quality must not be protected, so this part is very important, quality-oriented power plant must be aging. Anters all power supplies must be 100% aging before shipment.

Under the picture is the aging workshop of Anters, the production department employees are the power supply aging cabinets for aging.

10, testing, packaging After aging, we will again perform performance, parameter testing to ensure that the power supply meet the requirements.

Then labeling, packaging, send the quality department to do the final check.

11, Quality Department inspection

Production department to do the power supply quality department to do the final inspection test, qualified products issued product inspection report.

12, Shipping

Packaging and check the good power, you can put to the delivery area, ready to ship.


  • Newsletter
  • Categories
  • Contact Us

    TEL:+86-755-23765496

    E-mail:info@leomay.com

    Add:No.3178,Renmin Road,Minzhi Street,Longhua District,Shenzhen City,Guangdong Province,China


  • QR Code
  • Copyright © Leomay Technology Company Limited All Rights Reserved.